Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION ADJUST ANGLE OF BLADE EDGE (Angledozer, tiltdozer) WARNING in a 3 - 161 It is dangerous if the work equipm ent moves by mistak e when adjusting angle of the blade edge. Se stabl e condition , then stop the en gine and lock the wor k equipment securely with the work equipmen Adju st the ang le (θ) of the bla de edge to match th e type of soil.

ANGLEDOZER ength of the left and right braces the same, change To m ake the l ength of the left and right braces th e same distance ( l ) b etween the join ts and adjust the cu tting an gle Adju st distanc e ( l ) between t he joints as follows To I NCREASE distance ( l ), I NCREASE cutting angle ( To D ECREAS E distance ( l ), g angle (θ). The standard cutting angle (θ) The standard distance (l) betw een the joints is 12 92 mm ( 4 ft 3 in).

SEMI U-DOZE R Turn the brac e with bar handl e (1) and the distan ce ( l ) between the j oints to ch ange the cuttin g angle (θ) as follow INCREASE di stance ( l ) to IN CREASE angle (θ) DECREASE d istance ( l ) to D The standard cutting angle (θ) The standard distance (l) betw een the joints is 13 72 mm ( 4 ft 6 in).

Cutting angle θ Advantages Disadva Large Amount of soil spilled to rear of blade is small Separation of soil is good and little soil is carried back Soil digging resistance resistance are large Load pushed by blade Small Soil digging resistance and rolling-up resistance are small Load pushed by blade is large Cutting amount on rough surfaces is good Amount of soil spilled large Separation of soil is p carried back