Komatsu — GUIDES TO MAINTENANCE

. MAINTENANCE GUIDES TO MAINTENANCE CHECK SERVICE METER: Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. KOMATSU GENUINE OILS: For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature. 4 - 2 GUIDES TO MAINTENANCE Do not perform any i nspection and maintenance oper ation that is not fo Stop the machine on flat hard ground when p erformin g inspections and maintenance KOMATSU GENUINE REPLACEMENT PARTS: Use Komatsu genui ne parts specified in the Parts Bo ok as replacemen ALWAYS USE CLEA N WASHER FLUID:

Use automobile wind ow washer fluid, and be careful not to let any dirt g CLEAN OIL AND GR EASE: Use clean oil and gr ease. Also, keep the containers o f the oil and greas e clean. Keep foreign materials a way from oil and grease. CHECK FOREIGN MATERIAL IN DRAINED OIL : After oil is changed o r filters are replaced, check the ol d oil and filters for m etal particles and for eign materia ls. If l arge quantity of metal pa suitable action. rticles or foreign materials are found, always report to the person in charge, and carry out harge, carry FUEL STRAINER: If your machine is eq uipped with a fuel strainer, do no t remove it while f WELDING INSTRUCT IONS: Cut off power. Wa it for approx.

one minute after tu rning off the engin e starting switch key , and then di sconnect the negative (-) te rminal of the battery. e than 200 V continuously. g cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near ectors, etc., the instruments may malfunction. Do not apply mor Connect groundin g cable within 1 m (3.3 instruments, conn ectors, etc., the instruments may malfunction. If a seal or bearing happens to come between the p art being welded a nd grounding point, change the g rounding point to avoid suc h parts. ea around the work equipment pins or the hydraulic cylinders as the grounding point.

Do not use the ar ea around the work equipment pi ns or the hydraulic cylinders as the gro unding point OBJECTS IN YOUR P OCKETS: When opening ins pection windows or the oil filler p ort of the tank to carry out inspection, be careful n ot to drop nuts, bolts, or tool If such things are lead to failure. If s inside the machine. dropped inside the machine, it ma y cause damage and/or malfunction of the machine , an d will you drop anything inside the mac hine, always remo ve it immediately. r inspection. Do not put unnec essary things in your pockets. C arry only things wh ich are necessary fo r inspection.