. MAINTENANCE PERIODIC REPLACEMENT OF SAFETY CRITICAL PARTS 4 - 16 PERIODIC REPLACEMENT OF SAFETY CRITICAL PARTS ly replace the safety page. For usin g the machine safely f or an extended p eriod of ti me, you are required t o periodical (critical and fire prevention) rela ted parts listed in the table of importan t parts on t he following page. Material quality of these parts c an change as tim e passes and they ar e likely to w ear out or d eteriorate. However, it is diffic ult to determine the exte nt of wear or det erioration a t the time o f periodic m aintenance . Hence, it i s required to replac e them with new ones regardless of th eir conditio n after a c ll times.
ertain portant ensure t hat these parts maintai n their full performance at a Furtherm ore, should anything ab normal be found on any of t hese parts, replace it w ith a new on e even if th e periodic replace ment time for the part ha s not yet arrived . If any of the hose clamps show deterioration like deformati on or cracki ng, replace the clamps at the sa me time as the hose s. form the following checks with hydraulic hoses which need to be replaced periodically. Tighten all loose and replace defective hoses, as required. placing hoses, always replace O-rings, gaskets, and other such parts at the same time. ur Komatsu distributor replace the critical parts.
Also per clamps and replace defective h oses, as required When re placing hoses, always replace O-rings, gaskets, a nd other su ch parts at the same ti Have yo ur Komatsu distributor r eplace the critic al parts. SAFETY CRITICAL PART S Replace wear parts such as the filter element or air cleaner element at the time of periodic m aintenance or before they rea ch the wear limit. The w ear parts should be replace d correctly in order to e nsure more economic use of t he machine . When replacing parts , always use Ko matsu gen uine parts. part number may change, so inform your test part number when ordering parts.
As a res ult of our continuous efforts to improv e product quality, the numb Komatsu distributor of the mach ine serial numbe r and chec k for the la test part nu mber when ordering p NO.
Safety critical parts for periodic replacement Q' ty Replacement interval 1 Fu el hose (fuel tank - fuel strainer) 1 Every 2 years or 4000 hours, whichever comes sooner 2 Fu el hose (fuel tank - water drain valve) 1 3 Fu el hose (fuel strainer - additional water separator) 1 4 Fu el hose (additional water separator - engine entrance) 1 5 Fu el return hose (engine spout- fuel tank) 1 6 Fu el return hose (engine spill spout - fuel tank) 1 7 Ho se between torque converter oil cooler and power train assembly 1 8 Ho se between power train pump and power train filter 1 9 Ho se between power train filter and power train assembly 1 10 Ho se between transmission case and steering case 1 11 Po wer train pressure detection hose assembly 1 12 Ho se between end face of left pivot shaft and straight frame relay tube 2 13 Ho se between straight frame relay tube and blade tilt cylinder 2 14 Ho se between hydraulic pump and drain relay block 1 15 Ho se between drain relay block (power train) and hydraulic tank 1 16 Ho se between oil cooler and drain relay block 2 17 Ho se between fan pump and self pressure reducing valve 1 18 Ho se between self pressure reducing valve and fan motor 3 19 Ho se between PPC divider block and main control valve 2 20 Ho se between PPC divider block and fan pump 1