Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE WHEN REQUIRED CLEAN INSIDE OF COOLING SYSTEM WARNING The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC).

If you use another coolant, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. Supercoolant (AF-NAC) is already diluted with distilled water. When using coolant, investigate the lowest temperatures in the past and decide the density for the coolant from the coolant density table below. When actually deciding the density for the coolant, set it for a temperature 10 ° C (18 ° F) lbelow the actual temperature. The coolant density varies according to the ambient temperature, but it must always be a minimum of 30%.

Coolant density table Prepare a hose to use when filling with coolant. 4 - 21 Immediately after the engine is sto pped, the coolant is at a high t emperature and th e radiator i s under high i nterna l pressure. If the cap is remov ed to drain the co olant in this condition , there is a hazard of burns. Wait for th e temperature to go down, then turn t he cap slow ly to release the p ressure before removing it. Clean ing is carrie d out with the eng ine running. When s tanding u p or leaving the op erator's sea t, set the wor k equipment lock lever and the park ing lever to the L OCK position.

For de tails of star ting the engine, s ee "CHECK BEFORE STARTI NG ENGINE, ADJU ST (PAGE 3 -95)" and "STARTING ENGINE (PAG E 3-118)" in the OPERATION s ection. when the engine is running.There is danger of touching the fan. Never walk in fron t of the machine when the engine is r unning.Th ere is dang er of to uching the fan. It is ex tremely dan gerous to go und er the machine to clea n it when the engine i s runn ing. There i s danger that the machine may sudde nly move. Never go under th e machine when the engine is running .

Stop th e machine on level ground when cleaning or changin g the Clean th e inside o f the cooling sy stem, change the c oolant a ccording t o the t able belo Inte Antifreeze coolant rval for cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first Minimum Temp °C Abov °F Abo e -10 -15 -20 -25 -30 -35 -40 -45 -50 ve 14 5 -4 -13 -22 -31 -40 -49 -58 Concentration (%) 3 0 36 41 46 50 54 58 61 64