. MAINTENANCE SERVICE PROCEDURE WARNING 4 - 22 Antifreeze is toxic. When open th e drain valve, be careful not to get wate r containing antifreeze on yo u. If it gets in your eyes, flush your eyes with large amou nt of fresh water and see a doctor a t onc When changing the coolant or d raining the coolant from the radiato r bef ore carrying out repairs, ask a specialist company to handle any coolant containing drainage water ditches or drain i The coolant is already diluted w ith distilled water. (For details o f the distilled water, see "CO OLANT AND WATER FO heck the density with a coolan t tes 1. Turn cap (3) of the radiator water filler slowly.
coolant under drain valve (4) at the ain the water. ose drain valve (4), and fill with city full, start the engine and run at low ure to at least 90°C (194°F), then 10 minutes. valve (4), and drain the water. an the radiator with detergent. flushing operation, follow the ushing agent. dd Supercoolant to near the mouth of the water filler. lant density, see the COOLANT DENSITY TABLE. he coolant, run the engine at low un for a further 5 minutes at high water filler cap off.) sub-tank (5), flush the inside of r to between the FULL and LOW prox. 3 minutes, add Supercoolant port, then tighten the radiator cap 2. 3. 4. Set a container to catch the bottom of the radiator.
Open drain valve (4) and dr After draining the coolant, cl water. When the radiator is 5. 6. idling to raise the temperat continue to run for approx. Stop the engine, open drain After draining the water, cle When carrying out the instructions given with the fl 7. Close drain valve (4) and a dd Supercoolant to near the mouth For details of the Supercoo lant density, see the COOLANT 8. To bleed the air mixed in t he coolant, run the engine at l idling for 5 minutes, then r idling. (When doing this, leave the 9. Drain the coolant inside sub-tank (5), then add wate marks. 10. Stop the engine, wait for ap up to the bottom of the filler port, then tighten the radiator c (3).