. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE THE END BITS AND CUTTING EDGES WARNING work (Sigmadozer) [Unit: mm (in)] REMARK The tip (a) of mount plate (b) may wear away when the end bit and cutting edges are replaced and reversed. This wearing shape does not effect the blade life. 4 - 33 It is dangerous if t he work equipme nt moves by mistake when the cutting e dges a nd end bits are being rever sed or repla Set th e work e tabl sto engine and control equipment loc k lever. Reverse or r eplace the end bits and cutting edges befor e it is worn out to the blade end 1. Raise the blade to a proper height, position a block under the f rame t o prevent the blade from falling. 2.
Operate the work e quipme nt loc k lever to the LOCK position. 3. Measure the wear of the en d bit and cutting edge in accordanc e with the wear stan dards giv Wear standards Item Judgement standard No. Measurement position Standard dimension Permissible limit 1 Height of outside of end bit 300 (11.8") 235 (9.25") 2 Width of end bit 640 (25.2") 560 (22.0") 3 Height of inside of end bit 330 (12.9") 235 (9.25") 4 Height of cutting edge (from center of bolt mounting hole to end face) 165 (6.5") 105 (4.1") 5 115 (4.5")