Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 19. Close the inspection cover. 4 - 40 7. Loosen ring n 8. Remove scree n (8) from the water separa tor table, pulling the screen out do 9. Wash screen ( At that time, al so check it for damage and i f any, replace it with a new one. 10. Wash the inter ior of casing (7) for damag e, a crack or so bad a contaminatio n as to make it impossible to identify the location of float (9), an d if any of them is found, rep lace the casing with a new one. 11. Install screen (8) on the water separator t 12. Replace O-rin g (10) with a new one. 13.

Put float (9) in casing (7) the way it does n ot tilt, and then pour clean fuel in th e casing calmly. 14. Install casing ( 7) on the water separator ta ble and tighten ring nut (6). Tightening tor que: 16 - 20 Nm (1.6 - 2.0 k gm, 11.6 - 14.5 lbft) 15. Install water d rain plug (4). drain plug (4). que: 1.5 - 2.5 Nm (0.15 - 0.2 5 kgm, 1.1 - 1.8 lbft) 16. Tighten water Tightening tor 17. In case air int ake plug (5) has been loosened to drain fuel, que: 8.0 - 12.0 Nm (0.8 - 1.2 kgm, 5.8 - 8.7 lbft) tighten it now. Tightening tor 18. Turn fuel valve (3) to the "OPEN" position (O). 20.

When the who le work is finished, bleed ai r from the water separator th e same way as w hen replacing the fue filter cartridge. For the air ble eding procedure, see "BLE