Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT 4 - 88 1. Lowe r the wor k equipment to t he ground. 2. Set th e parkin g brake lever an d work equipmen t lock lever t o the LOCK positi Carry out Steps 3 - 5 within 15 sec When the engine i s stopped, the pr essure in th e accumulator gradually goes down . For thi s reason, the check can only be c arried ou t immediately aft er the engin e is s 3. Stop the engin 4. Turn the starti ng switch to the ON position 5. FREE then fully t he blade contro t, rear, left, and l lever and ripper right to release th control leve e pressure i the h ydraulic c 6.

Set th e work e quipment lock le ver to the L OCK position and turn the starting s witch to the OFF