. MAINTENANCE SERVICE PROCEDURE EVERY 4000 HOURS SERVICE WARNING the the a to 4 - 89 Maintenance for every 250, 500, 1000 a nd 2000 hou rs service should be c arried out at th REPLACE ACCUMULATOR (FOR CONTROL CIRCUIT) Replace the accu mulator every 2 years or every 400 0 hours, w hichever co The accumulator is charged with high-pressu re nitrogen ga s, so mista ken operation may cause an e xplosion, which will le ad to serious injury or da mage. When handling the accumulator, always do as follows. The pressure in the hydraulic circuit cann ot be complete ly removed . When removing the hydrau lic equipment, d o not s tand in the direction t the operation.
hat the oil spurts out whe n carrying out t he operatio n. In additio n, loosen the bol ts slowly when c arryin g out ble the accumulator. ear flame or dispose of it in fire. es in it or weld it. it, or subject it to any impact. Do not disassem Do not bring it n ear flame or dispose of it Do not make hol Do not hit it, roll it, or subject it to any imp When disposing of the accumulator, the gas must be re leased. Ple ase contact your Komatsu d istributor to hav e this work carried out. If operations ar e continued after t dropped, it will be i he performance of t mpossible to release t accumulator has mpossibl e to remaining pressu re in the hydraulic circuit if there should be chine.
Please ask your Komatsu distributor mulator. cuit if should be failure on the ma replace the accu The accumulator is installed to the posit ion shown in the diagr on the right. CHECK PLAY OF TURBOCHARGER ROT OR Contact your Kom atsu distributor to hav e the rotor pl ay checke CHECK ENGINE VALVE CLEARANCE, A DJUST Special tools are needed for inspection and maintenance, so c ontact your Komatsu distri