DETAILED CONTROLS AND GAUGES OPERATION SLIDING DOOR 0. (Machine equipped with cab) Be sure to check that the sliding door is locked in position both when it is open and when it is closed. Always stop the machine on level ground when open- ing or closing the door. If the door is opened or closed on a slope, there is danger that the operating effort will suddenly change. Do not open or close the door on slopes. When opening or closing the door, always use door handle (1) and knob (2). Be careful not to get your hands caught between the front pillar or center pillar. If there is anyone inside the cab, call out to that person before opening or closing the door.
When the sliding door is opened wide, the far end of the door overruns the machine's turning radius. Make sure that the door does not hit objects in the turning radius. NOTICE Foreign objects stuck in the door slide can cause a failure in the door when it is opened and closed. Peri- odically check and remove any foreign objects. Door Lock 0. When closing the door, pull the handle back to remove lock (3), then pull the door to the front. 3-22 CAUTION