(23) Guide the cardan shaft down into the bore so that the slot is parallel with the connection flange. 7405S STVLV50(1) (24) Place the gear wheel (rotor) so that the cross pin from item 33 is positioned in relation to two tooth bases - as the screw driver indicates. 7405S STVLV50(2) (25) Grease the two O-rings with mineral oil approximate viscosity 500 cSt at 20 C and place them in the two grooves in the gear rim. Fit the gear rim so that the seven through holes match the holes in the distributor plate. Turn the gear rim so that the smaller diameter of the holes face the distributor plate. ц 7405S STVLV50(3) (26) Orientate the holes with a single screw. 7405S STVLV50(4) 5-34