Komatsu — CHANGE OIL IN ENGINE OIL PAN,REPLACE ENGINE OIL FILTER CARTRIDGE

MAINTENANCE MAINTENANCE PROCEDURE EVERY 250 HOURS MAINTENANCE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE The parts and oil are at high temperature immediately after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. G Container to catch drained oil: Minimum 4 liters (1.06 US gal) capacity G Refill capacity: 3 liters (0.79 US gal) G Filter wrench 1. Set a container to catch the oil immediately under the drain plug (P) at the bottom of the machine. 2. Remove drain plug (P) slowly to avoid getting oil on your- self, and drain the oil. 3.

Check the drained oil, and if there are excessive metal particles or foreign material, contact your Komatsu dis- tributor. 4. Install drain plug (P). Confirm that no remnants of old packing still adhere to the filter holder as this may result in oil leakage. Check that there is no old packing affixed to the filter holder. If there is any old packing affixed to the filter, it will cause leakage of oil. 7. When installing; tighten until the packing surface contacts the seal surface of the filter holder, then tighten it up 1/2 to 3/4 of a turn. 8. After replacing the filter cartridge, add engine oil through oil filler (F) until the oil level is between the H and L marks on the dipstick (G). 9.

Run the engine idle for a while, then stop the engine and confirm that the oil level is between the H and L lines according to "CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL (PAGE 3-23)". 4-43 WARNING 5. Using a filter wrench, turn filter cartridge (1) counterclock- wise to remove it. A large amount of oil will come out if this procedure is carried out immediately after stopping the engine, so wait for 10 minutes before starting the maintenance. 6. Clean the filter holder, fill the new filter cartridge with clean engine oil, coat the thread and packing surface of the new filter cartridge with clean engine oil (or coat it thinly with grease), then install it to the filter holder. REMARK