MAINTENANCE MAINTENANCE PROCEDURE 3. Remove the cap from oil filler (F), and release the internal pressure. 4. Loosen the clamp of hose (1), then loosen 4 bolts. 5. Take out element assembly (2). 6. Using a filter wrench, turn filter cartridge (3) to the left to remove it. 7. Clean the filter holder, then coat of the seal surface of the new filter cartridge with engine oil (or coat it thinly with grease). 8. When installing, bring the packing surface into contact with the seal surface of the filter holder, then tighten a further 1/2 - 3/4 turns. NOTICE Be sure to pressurize the hydraulic tank.
If it is not pres- surized, the pump will suck in air, and this will adversely affect the equipment. 9. Leave hydraulic tank cap (F) removed, and extend the boom, arm, and bucket cylinders fully as shown in the diagram on the right. Then install the cap and pressurize the inside of the tank. 10. Install cover. 4-45