MAINTENANCE PROCEDURE MAINTENANCE INSPECT AND ADJUST COOLING FAN BELT TENSION Inspection The belt should deflect 10 to 15mm (0.4 to 0.6 in) when press with (A) finger force of approx. 58.8N (6kg, 13.2 lb) at a point midway between alternator pulley and fan pulley. Adjustment G Prepare a pinch bar G Prepare a wooden block 1. Tip the operator's seat over to the front, then remove the toolbox from under the seat. For details, see "TIPPING OPERATOR'S SEAT (PAGE 3-20)". 2. Remove 4 bolts (4) from the panel under the operator's seat, then remove the cover. 3. Insert a bar between alternator (1) and the cylinder block to fix alternator (1) in position.
When fixing alternator (1) in position, insert a wooden block between the bar and alternator (1) to prevent damage to the alternator. 4. Loosen bolts and nuts (2), (3) and (4). 5. Move alternator (1) with a bar so that the deflection of the belt is 10 to 15 mm (0.4 to 0.6 in) (approx. 6 kg (13 lb)). 6. Tighten the bolts and nuts (2), (3) and (4) to fix alternator (1) in position. 7. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom the V-groove. 8. If the belt is stretched, leaving no allowance for adjust- ment, or if it is cut or cracked, contact your Komatsu dis- tributor for replacement.
4-46