. OPERATION DETAILED CONTROLS AND GAUGES Supplying Grease (2) from grease can (1), then remove REMARK Put the spare grease can beside the grease pump in the grease pump box at the right side of the machine. 3 - 67 1. Remove 3 wing b cover (3) from the 2. Remove follow pla If the hollow in the cen ter of the follow plate is not fully filled with grease, air will be suck ed in and it may not be possible to use all the grease. 3. Fill grease can (1) with new grease, then set follo w plate (4) on top of the grease. Fill the hollow in before setting th top of the grease. the center of the follow plate with grease Fill the hollow in e following plate on top of the grease. 4.
Insert the pump int o the packing at the center of fo llow plate (4), set cover (3) on gr uniformly to hold in The pump will op first grease inclu and not suitable set cover (3) on gr ease can (1), then tighten 3 wing bolts (2) position. uniformly to hold in The pump will op erate for a short time and then stop, but the des air inside the pump, so it is cloudy white for use. 5. Loosen check valv e (5), and pump out all the grea se which has air in it from hole (6 ) at the bottom of check valve (5). rely. 6. After bleeding the air, close check valve (5) secu 7.
After bleeding the a ir inside the pump, pull the lev er of the greas e gun to completely disch arge the grease mixed with air inside the When filling with portion. If there is ample set in position, s The standard gr be more grease with air inside the hose and grease gun. When filling with grease, be extremely careful not to let san d or dirt stick to the follow plate or pump suction If there is ample grease, but the pump does n ot pump out a ny grease,the follow plat e may not be correctly o set it in position again corre ctly. The standard gr ease can contains 16 liters (4. 23 US gal). If an 18 liters (4.76 US gal ) can is used, there wil left.