. OPERATION DETAILED CONTROLS AND GAUGES ACCUMULATOR WARNING on the right. 3 - 68 The accumulator is charg ed with high-pressure nitrogen g as, imprope r operation may cause an explosion which co uld lead to serious injury or damage . When handling the accumulator, always do as follows: Pressure in the contro l circuit cannot be completely re moved. Whe n removing the hydraulic equipment, do not s tand in the direction that oil spurt s out when performing the operat Loosen the bolts slow Do not disassemble th Do not bring it near fla Do not make holes in i Do not hit it, roll it, or When disposing of the accumulator, the gas must be rel eased.
Con tact your Komatsu distrib utor for proper disp This machine is equipp edwith an accumulatorin the c ontrol circ uit. The accumulatoris a device to store o il pressure for the control circuit. Because an accumulator is ins talled, the control circuit can be a ctuated for a short time even after the engine is stop ped. As a result, if the contro l lever is m oved in the LOWER di rection, the work equipment will go down under its The accumulator is ins talled to the position shown in Releasing Hydraulic Pressure with Accumula 1. Place the work eq 2. Stop the engine. 3. Turn the key in sta 4. Move lock lever to strokes back and f 5. Move the lock leve 1.
Place the work eq uipment on the ground. Close the crushe r attachment jaws, etc. 2. Stop the engine. 3. Turn the key in sta rting switch to the ON position 4. Move lock lever to the free position. Move the wo rk equipm ent control lever and att achment control p edal to full orth, right and left to release p ressure in the control circuit. ontrol pedal. 5. Move the lock leve r to the LOCK position. Lock t he control lever and attachment c