. OPERATION MACHINE OPERATIONS AND CONTROLS In Cold Weather Areas 2. Set safety lock lever (1) to the FREE position and raise the bucket from the ground. 3 - 95 (AUTOMATI C WARMING-UP OPERATION) When startin g the engine in c old areas, c arry out the automa tic warming-up operation aft When the en is performed the engine water temperature i s low (below 30°C (86°F), th e warming-up operation engin temperature (30°C (86 °F) or if the warming-up operati on continues for 10 minutes. If the en gine coolant or hydraulic oil temperatu res are low after 10 minutes , continue to warm t NOTICE Do not sudd enly accelerate the engine before the warming-up operation is complete Do not run t minutes.
Th d. he engine at low or high idle continuously for more than 20 is will cause oil leaks from the turbocharger oil supply piping. If it i to time or ru Never perf s necessary to run n the engine at a orm operations or the engine at mid-range sp operate th idle, apply a load from time eed. e control levers when the hydraulic oi operation u l is still a low temp ntil the hydraulic o erature. Alwa il temperatur ys continue th e monitor dis e warming-up play is green. This will ext end the service lif e of the machine. REMARK If the hydraul ic oil temperatur e is low, the hydraulic oi l temperatur e monitor display will be . Turn fuel control dial (2) t o the mediu m speed po