Komatsu — BUCKET REPLACEMENT

. OPERATION MACHINE OPERATIONS AND CONTROLS BUCKET REPLACEMENT WARNING Replacement 1. Place the bucket in contact with a flat surface. 3 - 117 Wh en pins are knocked in with a hammer, pieces of met al may fly and cause seriou s injury en carrying out this op eration, always wear goggles, hard hat, gloves, and other protective e quipment. Wh en the bucket is remov ed, place it in a stable conditio If p ins are hit with a strong force, there is a hazard that the pin may fly ou t and i njure p eople i n the surrounding area. Ma ke sure t there is no one in the surrounding area before starti ng the operation. Wh en removing the pins, d o not stand behind the bucket.

In addition, be extremely ca reful n ot to p ut your foot under the bucket ile standing at the side Wh en removing or insertin g pins, be extremely careful n ot to get your f ingers caugh Ne ver insert your fingers i nto the pin holes when alignin g the holes. Stop the machine on a firm and flat surface and do th e work. When performing joint work , appoint a lead and follow that p erson's instructions NOTIC E When removing the bucket, s et the bucket cylinder facing d own as shown in the diagram in the right to prevent the front link from jum ping up under the we ight of the bucket cylin der. REMA RK removing the pins, place the bucket so that it is in light ct with the ground.

bucket is lowered strongly to the ground, the resistance will creased and it will be difficult to remove the pins. When conta ct with the ground. If the bucket is lowered st rongly to the ground, the re be in creased and it will be difficult to remove the pins