. MAINTENANCE MAINTENANCE PROCEDURE WARNING 4 - 29 REPLACE BUCKET TEETH (VERTICAL Replace the buc ket tooth before it wears d own to the adapter. When replacing the bucket teeth, do not re place only both sides with new parts. If both sides only are replaced with new parts, t he bucket will easily defor It is extremely dan gerous if the work equipment moves unexpectedly when the teeth are being replaced. Set the work equip ment in a stable condition, sto p the engine, then set safety lock lever (1 The pin must be hi ) securely to the LOCK positio t strongly to remove it, so ther n. e is danger of the pin flying out.
Make s ure that there is no person in the surrounding area before removing th There is danger e pin. of broken pieces flying during the replacement ays wear protective glasses, gloves, and other nt. operation, so alw protective equipme 1. Prepare the rep lacement tooth, tools, and (1) Pin (2) Tooth (3) Hammer jig lded to bucket) (4) Pin removal (5) Adapter (we 2. Set a block und er the bottom face of the b ucket so that pin (1) can be remove d. Turn the starting switch nds after stopping the e to the ON position within 15 seco ngine, operate the control levers f ully, check that the work e quipment is stable, position. s horizontal.
then set the saf ety lock lever to the LOCK Set so that the bottom face of the bucket i 3. Put the short p art of pin removal jig (4) in contact with the top surface of pin ( 1), then hit it with hammer ( 3).