Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE tooth (2) counterclockwise and remove it from adapter (5). check the direction of pin (1) and insert it. 4 - 30 4. Whe n the sh t of pi n remova l jig (4) enter s fully, put the long part in c ontact with p in (2) an d remov e the pin. 5. Turn 6. Clea rtion 5). I any mud, sand, o r grave l stuck to it, the tooth wil l not e nter properly, and i t will be impossible t o knock i n the pin 7. Turn replace and it into a dapter ( 5). Continue to insert it unt il th e toot h contacts the tip of the ada 8. Whe n tooth ( 2) is pushed securely into t he n ose of adapter (5),