Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE WARNING so that the pin (1) of hammer. Set so that the REMARK this mothod, 4 - 32 REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) Replace the teeth bef ore the wear reaches t he adapte It is dangerous if the w ork equipment moves by mistake w hen the t eeth are being replaced. Set the work equipme nt in a stable condition, t hen stop th e engine and set The the lock lever sec pins can be knock urely to the LOCK positio ed out only with strong f n. orce, so there is a hazard that the pin may fly out. Check that there is no one in the surrounding area.

There is a hazard that fragments will fly during the replacement work, so always wear protectiv e equipment like safety g lasses and gloves. 1. tooth (2) can be k nocked out with a ha bottom face of the 2. Place a bar on the head of pin (1), hit the bar with a hamm er to knock out the pin, then remove tooth (2) I f t have your Komats u distributor replace th e bucket t 3. Clean the mounti ng face. Fit a new too th (2) in t he adapter, push in pin (1) par tially by hand, then loc k it with a hamm er to install the tooth to the bucket.