. MAINTENANCE MAINTENANCE PROCEDURE BLEEDING AIR FROM HYDRAULIC SYSTEM Bleed the air from the various components in the order below (1 - 5). 1. Bleeding air from pump 1) Loosen air bleeder(1) and check that oil oozes out from the air bleeder. 2) If no oil oozes out, remove the drain hose from the pump case, and add hydraulic oil through drain port (2) to fill the pump case. Oil will come out when the drain hose is removed, so secure the hose mouthpiece at a position higher than the level of the oil in the hydraulic tank. 3) After completing the air bleed operation, tighten air bleeder (1) and install the drain hose.
NOTICE If the drain hose is installed first, oil will spurt out from plug (1) hole. If the without filling the pump case with hydraulic oil, abnormal heat will be generated and this may cause premature damage to the pump. 4 - 37 For details, s ee "STARTING ENGINE (PAGE 3-87)". If it is necessary to refer to the i tems for starting the engine, moving the NOTICE ir as follows. ork equipment, swing) uipment circuit gine at less than 1000 rpm, and operate the cylinders slowly. denly stop and cause the cylinder pressure to rise or operate to the end of the stroke. ating the cylinder for the first stroke (extending and retracting), operate particularly slowly. Bleed the a 1. Pump (w 2.
Work eq Run the en Do not sud denly stop and cause the cylinder pressure to rise or operate to the end of the str When oper ating the cylinder for the first stroke (extending and retracting), operate particular When oper ating the cylinder for the first stroke, there is a large amount of air inside the circuit , so the work equipment will not move for at least 10 seconds. Be careful not to operate the lever to the end of the stroke. il of NAS7 class or above when filling the pump. Be sure to use a clean oil can. Use clean o If the drain ho pump is ope abnormal heat