Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE 2. Starting engine Start the engine according to "STARTING ENGINE (PAGE 3-87)" keep running the engine at low idle for 10 minutes, and carry out the following procedure. 3) After completion of bleeding air, install air hose (1). 4 - 38 3. Bleeding air from cylinders 1) Run the engine at low idle, and extend and retract eac not moved to the end of its stroke. (Stop the cylinder a 2) Next, operate each cylinder 3 to 4 times to the end of 3) Finally, operate each cylinder 4 to 5 times to the end o h cylinder 4 to 5 times, taking care that a cy linde r is pprox.

100 mm (3.9 in) short of its stroke en NOTICE If the engine is run at high speed immediately after startup or a cylinder is pushed up to its stroke end, air taken inside the cylinder may cause damage to the piston packing. 4. Bleeding air from swing motor (bleed the air only when the 1) Run the engine at low idling, remove air hose (1), check that oil oozes out from air hose (1). NOTICE Do not operate the swing under any circumstances. 2) If the oil does not ooze out, stop the engine, remove hose (1), then fill the motor case with hydraulic oil. 4.

Bleeding air from swing motor (bleed the air only when the oil inside the swing motor case has been d rained) and air tructure at least 2 times uniformly to the left a nd right. NOTICE If the air is not bled from the swing motor, the motor bearings may be 5. Bleeding air from attachment (when installed) If an attachment has been installed, run the engine at low (approx. 10 times) until the air has been bled from the atta idling and operate the attachment pedal rep eatedly chment and circuit. NOTICE If the method of bleeding the air from the attachment itself is spe cified by the manufacturer, bleed the air accordi ng to the specified procedure.

After completing the air bleeding operation, stop the engine, and le ave the machine for 5 minutes before starting op erations. This will remove the air bubbles in the oil inside the hydraulic cylin ders. een spilled. Check that there is no leakage of oil and wipe off any oil that has b