Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS, FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS (only machines equipped with air conditioner) WARNING NOTICE 4 - 60 If compressed air, high-pressure wat er, or steam hits you r body directly or dirt is sent flying by the comp ressed air, high-pressure water, or steam , there is danger of p ersonal injury. Alwa ys wear protectiv e glasses, dust mask, and ot her protective equipment.

When using co mpressed air, use fro m a distance to prev ent damage to t In particular, w ith the fuel cooler and aftercooler, blow w ith compressed air at an angle of 45° with the nozzle at a distance of at least 300 mm ( Never blow the compressed air at rig ht angles to the cor e. If the fins are d amaged, it may cause coolan t leakage or overheating. O n dusty jobsi tes, check the fins da ily, irrespective of th e maintenance i 1. Open du cts (1) and (2) at the rear on the right side of the machine. Remove (2). 3 bolts (3) to open d uct (1) and 2 bolts (4) to open duc mud, dust or leaves clogging the radiator fins (E), oi 2.

Blow off ator fins (E), oi cooler fin compress At the sa the cond condition Steam or s (D), fuel cooler fins (B) and after cooler fins (C) using ed air. me time, clean the net in front of the o il cooler. Clean enser fins (A) on machines equipped with ai er. water may be used instead of compressed air. water may be use d instead of compr 3. Check th e rubber hose. Rep lace with a new o ne if the hose is found to Also, che After cool ± 0.05 kg have cracks or to b e hardened by agi ng. ck hose clamps for er hose clamp tight looseness. ening torque: 9.81 ± 0.49 Nm (1.0 m , 7.2 ± 0.36 lbft)