. MAINTENANCE MAINTENANCE PROCEDURE CLEAN ENGINE BREATHER 4. Replace the breather O-ring with a new part, coat with engine oil, and install it. Check the breather hose, and if there is any oil sludge on the inside, replace it with a new hose. run out of grease, so contact your Komatsu distributor for sooner. 4 - 79 Loosen cla Remove b Wash the it dry with Replace th mp (1), then remove olt (2), then remove whole breather in die compressed air. e breather O-ring wi CLEAN, CHECK TURBOCHAR GER Contact your K omatsu distributor f or cleaning or inspection.
CHECK PLAY TURBOCHARGER ROTOR Please contac t your Komatsu distri butor to have the rotor pl CHECK ALTERNATOR, STARTING MOTO The brushes have inspection or r When the eng spection ev ery 1000 hours or eve CHECK ENGINE VALVE CLEARANCE, ADJUS Special tools a re needed for inspe ction and maintenance, s o contact your Komats CHECK ENGINE INJECTOR SET LOAD, ADJUST (ONLY AFTER THE 2000 HOURS As special tool is required for chec king and adjusting the pa rts, request Komatsu d