. ATTACHMENTS AND OPTIONS AUTO-GREASING SYSTEM PROCEDURE FOR BLEEDING AIR FROM GREASE LINE WARNING been disassembled and assembled again, and 6 - 20 There is no che ck device to prevent reverse flow in th e service grease nipple in stalled t o the injecto r. If you forget to tigh ten the cap , there is da nger that high-pressure grease may s purt out when the grease pump is Be sure not to f If t large amounts of air have got into the grease li ne, bleed the air from th NOTICE If ai r is left in the circuit, the grease pressure will not r ise to the specified level or will tak e a long time to rise to th e specifie d level, and the injector will not wor k normally.
Items to chec k Loosen the plug installed to each injector to bleed air from the main piping . This work shall be carry out by two persons. ing at the injector nearest the grease pump, then bleed at the other injectors in order. le -> Boom cylinder bottom -> Boom -> Arm) the auto-greasing/grease gun selector valve lever inside the battery case is at the auto-greasing Start bleed ing at the i njector nearest the gre ase pump, then bleed a t the o ther injecto rs in order. (Swing circ le -> Boom cylinder bottom -> Bo Check that position. Method of ble eding air lug (2) from injector (1). ug (2) is installed to the manifold end of each end .
If air must be bled from the main piping, remove this person should set the auto-greasing switch on the side of the console on the right side of the operator's MANUAL position and operate the grease pump. s of the method of operating the grease pump, see ION (PAGE 6-14)". 1. Remove p This pl injector plug. 2. The other box on the seat to the For detail "OPERAT 3. Discharge of the air.) 4. When nor Remove p This pl lug (2) from ug (2) is in . If air must be bled from the main person should set the auto-grea side of the console on the right si The other box on the seat to the For detail "OPERAT MANUAL position and operate t s of the method of operating the ION (PAGE 6-14)".
ION (PAG Discharge the air with the grease from the in jector plug hole. (Often the gr ease beco mes cloudy white be cause of the air.) When nor mal grease comes out, set the au to-greasing switch to th e OFF position a nd stop the grease pump.