Komatsu — MAINTENANCE

. ATTACHMENTS AND OPTIONS AUTO-GREASING SYSTEM ATTACHMENTS AND OPTIONS AUTO-GREASING SYSTEM 5. Tighten plug (2) of the injector to prevent the grease from leaking. 14.5 - 21.7 lbft) REMARK normal, indicator pin (5) moves up and down in a piston movement. 6 - 21 Tightening torque of plug (2 ): 19.6 - 24.9 Nm (2.0 - 3.0 kgm, Carry out Steps 1 to 5 for eve 6. Remove cap (4) from service grease nipple (3) of the injector. 7. Operate the grease gun manu ally to fully charge all the branch lines with grease.

For details of the location of th e injectors, see "Greasing Points for Auto-greasing System (PA f th e auto-greasing system does not work properly and grease is not supplied, use the grease gun and carry out greasing manually rom service grease nipple (3) ins 8. Tighten cap (4) of service gre ase nipple (3) of the injector. Tightening torque of cap ( kgm, 2.9 to 4.3lbft) There is no check device to grease nipple (3). If you f danger that high-pressure grease pump is actuated. the cap. 9. After completing the operatio 4):

3.92 to 5.88 Nm (0.4 to 0.6 There is no check device to prevent reverse flow in service orget to tighten cap (4), there is grease may spurt out when the Be sure not to forget to tighten n in the Steps 1 to 8, set the 9. auto-greasing switch on the b ox on the side of the console on the right side of the operator's seat to the AUTO position. 10. Turn the machine starting swi tch ON and check that indicator pin (5) of each injector is wor king properly. If the condition is