Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-126 Install and tighten the coolant inlet tube to the fitting. Torque Value: 40 [30 ft-lb] Fuel Pump Support Bracket - Installation Install the fuel pump support bracket to the cylinder block with two mounting capscrews (M10-1.50 x 40). Torque Value: 47 [35 ft-lb] Air Compressor - Installation NOTE: To reduce noise and vibration, the air compressor must be timed with the accessory drive. Position the timing mark on the air compressor crankshaft at the 12:00 o’clock position.
Position the accessory drive shaft dowel pin at the 2:00 o’clock (accessory drive pulley at TDC) position as viewed from the front of the engine. Install the spline coupling on the accessory drive shaft. The gasket surfaces of the accessory drive and air com- pressor must be clean and free of damage.