Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-128 Fuel Pump (With Air Compressor) - Installa- tion Install the spider coupling to the end of the air compressor crankshaft. Use a new gasket to install the fuel pump. Install the two outside 12 point mounting capscrews (7/ 16-14 x 1-1/4). Install the two fuel pump support bracket capscrews (3/ 8-16 x 1) to the cylinder block bracket. Tighten the four fuel pump mounting capscrews. Torque Value: 45 [35 ft-lb] Tighten the two support bracket to cylinder block mount- ing capscrews. Torque Value:
45 [35 ft-lb] Fuel Pump (Without Air Compressor) - Installation Install the spider coupling to the end of the accessory drive shaft. Install the new o-ring on the accessory drive oil drain plug and install the plug into the accessory drive. Use a new gasket and install the fuel pump on the ac- cessory drive. Install four capscrews (M10-1.50 x 45) and four nuts (M10- 1.50). Torque Value: 47 [35 ft-lb]