Engine Disassembly (0-01) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-14 Fan and Fan Hub - Removal If an electric fan clutch is used, disconnect the fan clutch connector from the base wiring harness. Remove the six capscrews and the fan. NOTE: The six capscrews also hold the fan drive pulley in position. Do not allow the pulley to fall. Remove the fan drive pulley. Remove the four capscrews and the fan hub. Alternator Belt (Non Bus Applications) - Removal Loosen the adjusting screw locknut (1). Loosen the adjusting link capscrew (2). Loosen the pivot capscrew and nut (3). Turn the adjusting screw (4) to release tension, and re- move the belt.