Engine Disassembly (0-01) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-32 Remove the remaining 32 capscrews starting from the ends and moving toward the center. NOTE: The illustration shown is for torquing the cylinder head during installation. Reverse the order for removal. Install cylinder head lifting bracket, Part No. 3822479, on the center of the cylinder head. NOTE: If the capscrews are not available from the kit, install two rocker lever support capscrews (M14—2.00 x 135) (1) and two rocker lever housing capscrews (M10—1.50 x 115) (2). Torque Value: 47 [35 ft-lb] The component weighs 23 kg [50 lb] or more.
To avoid personal injury, use a hoist or get assistance to lift the component. To prevent damage to the cylinder head, lift it straight up. The cylinder head is doweled to the cylinder block. To prevent damage to the combustion face of the cylinder head, place it on wooden blocks after removal. Use a hoist or hydraulic arm to remove the cylinder head. Remove the gasket. Cam Follower Assemblies - Removal Remove the nuts and washers from the seven supports. Do not allow the nuts or washers to fall into the engine. NOTE: The cam follower assembly consists of two shaft assemblies with a common center support. Slide the cam follower removal and installation tool, Part No.
3824519 under the cam follower and around the supports. If necessary, bump the dowel supports to loosen. Slide the tool forward until the adjusting screws on the top of the tool can be finger tightened in to the socket of the injector cam followers.