Section 0 - Engine Disassembly and Assembly - Group 00 Engine Disassembly (0-01) M11 Page 0-33 Lift the cam follower assemblies to remove them from the engine. Remove the tool from the cam follower assemblies. Lubricating Oil Pan - Removal Rotate the engine on the rebuild stand to position the engine on its side. Remove two capscrews at points (1) and (2) and install two guide pins, Part No. 3376488. Remove the remaining 32 capscrews and oil pan. Use a mallet to loosen the oil pan if it is stuck. Remove the guide pins. Lubricating Oil Transfer Tube - Removal Remove the oil transfer tube from the oil pan on rear sump lubricating oil pans. NOTE:
The straight transfer tube is used on some aluminum front sump oil pan applications. Remove and discard the two o-rings from the transfer tube. Block Mounted Front Sump Suction Tube - Removal If the engine is equipped with a block mounted front sump suction tube, remove the suction tube retaining capscrew from the cylinder block. Remove the suction tube from the cylinder block. Remove and discard the o-ring from the suction tube.