Engine Disassembly (0-01) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-34 Flywheel - Removal Install two capscrews (M10-1.50 x 40) at points (1) and (2). Remove two mounting capscrews (3) and install two guide pins, Part No. 3376696. NOTE: On engines equipped with a rear engine power take- off (REPTO), two guide pins, Part No. 3376696, are required to support the crankshaft gear until the rear crankshaft oil seal is removed. The clutch pressure plate capscrew holes are U.S. Cus- tomary threads. They can be (3/8-16), (7/16-14), or (1/2- 13).
Make sure to measure a pressure plate mounting capscrew before installing the "T-handles" for lifting to prevent damage to the flywheel. Install two (4) and (5) into the flywheel. Remove the remaining seven mounting capscrews from the flywheel. The component weighs 23 kg [50 lb] or more. To avoid personal injury, use a hoist or get assistance to lift the component. Install the nylon lifting sling, Part No. 3375957, on the two and attach a hoist to the lifting sling. Tighten capscrews (1) and (2) in alternating sequence to loosen the flywheel. Use a hoist to remove the flywheel. Remove the capscrews (1) and (2) and the guide pin.