TROUBLESHOOTING / Troubleshooting A MC FAULT CODE 11304 Disconnect connector MC-C of MC. Check for continuity in harnes between terminal #C2 of harness end of connector MC-C in MC and terminal #2 in travel pilot in pressure sensor. YES Open circuit in harness between MC and travel pilot pressure sensor. YES To A NO Open circuit in harness between MC and travel pilot pressure sensor (terminal #3). Switch travel pilot pressure sensor with other pressure sensor and retry. Check if fault code disappears. YES Check if voltage between terminal #1 of harness end of connector in travel pilot pressure sensor and machine is specification. · Key switch:
ON NO Open circuit in harness between MC and travel pilot pressure sensor (terminal #1). · Key switch: ON · Specification: More than 0.25 V, Less than 4.75 V NO Faulty travel pilot pressure sensor. Connector (Harness end of connector viewed from the open side) Pilot Pressure Sensor (Travel) MC Connector MC-C Check if voltage between terminal #C2 of harness end of connector MC-D and machine is 0 V. YES Faulty MC. #C2 A Shorted circuit in harness between MC and travel pilot pressure sensor. · Key switch: ON NO C23 C31 T5-6-82 Fault Code Trouble Cause Influenced Control 11304-3 Abnormal Travel Pilot Pressure Sensor High Voltage Voltage:
4.75 V or higher • Auto-Idle Control • Idle Speed-Up Control • ECO Control • Travel HP Mode Control • Heater Control • Travel Torque-Up Control • Pump 1 Flow Rate Limit Control • Pump 2 Flow Rate Limit Control • Travel Motor Swash Angle Control • Attachment Flow Rate Control • Travel Alarm Control 11304-4 Abnormal Travel Pilot Pressure Sensor Low Voltage Voltage:
Less than 0.25 V • Auto-Idle Control • Idle Speed-Up Control • ECO Control • Travel HP Mode Control • Heater Control • Travel Torque-Up Control • Pump 1 Flow Rate Limit Control • Pump 2 Flow Rate Limit Control • Travel Motor Swash Angle Control • Attachment Flow Rate Control • Travel Alarm Control Disconnect connector of travel pilot pressure sensor. Check if voltage NO between terminals #1 and #3 of harness end of connector is 5±0.5 V. YES C1 C10 1 2 3