hitachi — MC FAULT CODE 11405

TROUBLESHOOTING / Troubleshooting A MC FAULT CODE 11405 valve unit (SI) (travel motor fast speed selection). · Between terminal #A5 of connector MC-A in MC and terminal #2 of connector in solenoid valve unit (SI) (travel motor fast speed selection). Connector (Harness end of connector viewed from the open side) MC Connector MC-A T183-05-04-008 T1V1-05-04-003 T5-6-89 Fault Code Trouble Cause Influenced Control 11405-2 Abnormal Current Feedback of Solenoid Valve Unit (SI) (Travel Motor Fast Speed Selection) Current:

Both of Higher than 920mA or Less than 60 mA Travel Motor Swash Angle Selection Control 11405-3 Abnormal Feedback High Current of Solenoid Valve Unit (SI) (Travel Motor Fast Speed Selection) Current: Higher than 920mA Travel Motor Swash Angle Selection Control 11405-4 Abnormal Feedback Low Current of Solenoid Valve Unit (SI) (Travel Motor Fast Speed Selection) Current: Less than 56 mA Travel Motor Swash Angle Selection Control Switch connectors of Faulty solenoid valve unit solenoid valve unit (SI) NO (SI) (travel motor fast (travel motor fast speed speed selection). selection) and other YES solenoid valve unit (SF, SC or SG). Check if fault code in Faulty MC.

switched solenoid valve YES Check for continuity in unit is displayed. harness between MC and solenoid valve unit (SI) (travel motor fast speed selection). · Between terminal #A31 of connector MC-A in Open circuit in harness. MC and terminal #1 of connector in solenoid NO Open circuit in harness. NO #A5 #A5 Solenoid Valve Unit (SI) #A31 (Travel Motor Fast Speed Selection)