Lubrication System/Oil Pan CTM3274 (01JUL99) 25-37 Saran Liter Engines 060799 PN=198 OIL PAN INSTALLATION 1. Place LOCTITE® 515 Sealant (or an equivalent sealant) on oil pan rail where flywheel housing, front plate and timing gear cover are attached to the cylinder -UN-10MAY95 block. NOTE: A tube of LOCTITE® 515 Sealant is provided with overhaul gasket set. This tube is also available under part number DD15664. CD30419 2. Select and install the correct gasket for the oil pan being used. 3. Install oil pan and tighten cap screws as follows: Oil pan (all types) to aluminium timing gear cover . . . . . . . . . . . . . . . . . . . . . . . .
50 N·m (35 lb-ft) Oil pan (all types) to composite -UN-10MAY95 material timing gear cover . . . . . . . . . . . . . . . . . . 30 N·m (22 lb-ft) Sheet metal oil pan to block and flywheel housing . . . . . . . . . . . . . . . . . . . . . 50 N·m (35 lb-ft) Aluminium oil pan to block and flywheel housing . . . . . . . . . . . . . . . . . . . . . . . . 50 N·m (35 lb-ft) Cast iron pan to block and flywheel CD30438 housing: SAE 5 screws (3 dashes) . . . . . . . . . . . . . . . . . 50 N·m (35 lb-ft) SAE 8 screws (6 dashes) . . . . . . . . . . . . . . . . . 70 N·m (50 lb-ft) 4. On 3000/3010 Series tractors, tighten the two cap screws (A) to 320 N·m (235 lb-ft). 5.
Install a new seal onto cylindrical drain plug. Tighten as follows: Cylindrical plug . . . . . . . . . . . . . . . . . . . . . . . . . . 70 N·m (50 lb-ft) Conical plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55 N·m (40 lb-ft) LOCTITE® is a registered trademark of Loctite Corporation. CD,3274,G25,35 -19-04JAN99 25 37