Cylinder Head and Valves CTM100 (06APR04) 02-020-29 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=101 Clean and Inspect Cylinder Head IMPORTANT: DO NOT USE scouring pads or wire brush to clean gasket sealing surface (combustion face). Doing so may affect sealing ability of gasket joint. –UN–06DEC97 DO NOT “hot tank” clean cylinder head unless all plugs and valve guides are removed for replacement. Hot tank solution will destroy lubricating RG8266 properties of valve guides. Fuel Rail 1. Inspect combustion face for evidence of physical A—Supply Rails (Dual Rail System Shown) damage, oil or coolant leakage, or gasket failure prior to cleaning the cylinder head.
Repair or replace cylinder head if there is evidence of physical damage such as cracking, abrasion, distortion, or valve seat “torching.” Inspect all cylinder head passages for restrictions. 2. Inspect around injector sleeve for evidence of fuel or coolant leakage. 3. Scrape gasket material, oil, carbon, and rust from head. Use a powered brass or copper (soft) wire brush to clean sealing surfaces. DO NOT use a steel wire brush. 4. Clean valve guides using a plastic brush. IMPORTANT: During engine repair or overhaul, cleanliness of fuel supply rail(s) (A) is extremely important due to fuel flow through passages.
Think of the fuel rails as internal passages of an injection pump; therefore, same cleanliness must be maintained. 5. Remove fuel rail expansion plugs in front of cylinder head and thoroughly clean fuel rail passages using a rifle-type cleaner (solvent). All debris must be removed from fuel rail. 6. Dry with compressed air and blow out all passages. Continued on next page RG,RG34710,80 –19–03SEP02–1/2 02 020 29