Delphi — Replace Unit Injector Sleeve in Cylinder Head Using JDG981

Cylinder Head and Valves IMPORTANT: Old injector sleeve (B) with one O-ring MUST be replaced with new injector sleeve (C) with two O-rings. IMPORTANT: DO NOT use engine oil or any petroleum based product as a lubricant for the injector sleeve o-rings. A chemical reaction will occur, leading to o-ring failure. Instead use a soap based solution to lubricate the packing. RG12417 –UN–04SEP02 2. Lubricate injector sleeve (A) with clean engine oil and push into sleeve bore with minimal pressure until tightly seated.

Installing Injector Sleeve A—Injector Sleeve B—Old Injector Sleeve C—New Injector Sleeve RG12415 –UN–04SEP02 CTM100 (06APR04) 02-020-41 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,92 –19–28NOV00–3/6 040604 PN=113 Install Unit Injector Sleeve 1. Grease square packing (A) and sleeve bore in head with JDT405 High Temperature Grease and install in packing seat area of injector sleeve bore. Take care that packing is not twisted during installation. –UN–05DEC97 A—Square Packing RG8152 Installing Injector Sleeve Packing RG,RG34710,92 –19–28NOV00–2/6 02 020 41