Delphi — Replace Unit Injector Sleeve in Cylinder Head Using JDG981

Cylinder Head and Valves Replace Unit Injector Sleeve in Cylinder Head Using JDG981 Remove Unit Injector Sleeve 02 020 NOTE: Cylinder head must be removed to replace EUI sleeve using JDG981 Unit Injector Sleeve Installation Set. To replace EUI sleeve with head installed refer to REPLACE UNIT INJECTOR SLEEVE IN CYLINDER HEAD USING JDG1184 later in this group. 40 RG8151 –UN–05DEC97 IMPORTANT: Whenever EUI is replaced, sleeve in cylinder head must be replaced also. Removing Injector Sleeve A—MAY-25010 Punch B—Wood Block JDG981-2 Swedge is obsolete. Disgard this tool and replace with JDG1184-2-1 Swedge Rod and 8132 Adapter. 1. Remove cylinder head from engine.

(See REMOVE CYLINDER HEAD, earlier in this group.) 2. Remove valves from cylinder head. (See REMOVE VALVE ASSEMBLY, earlier in this group.) 3. Using a 51 mm by 102 mm (2.0 in. by 4.0 in.) block of wood (B) at least 914.4 mm (36.0 in.) long, lay cylinder head on its side with air intake manifold mounting surface resting on block of wood. 4. Drive injector sleeve from combustion face side of cylinder head using MAY-25010 Punch (A) from JDG981 Unit Injector Sleeve Installation Set and hammer. 5. Remove square packing from injector sleeve bore. Thoroughly clean sleeve bore and inspect sleeve tip seating area for damage.

Continued on next page RG,RG34710,92 –19–28NOV00–1/6 CTM100 (06APR04) 02-020-40 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=112