Cylinder Head and Valves CTM100 (06APR04) 02-020-39 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=111 IMPORTANT: Replacement valve springs (R133891) have higher working loads than older springs (R116585). Newer valve springs (R133891), have two green paint stripes for identification. Valve springs must be replaced in sets of two with new rotators. DO NOT intermix springs –UN–06DEC97 across valve bridges. 4. With cylinder resting on combustion face, install valve springs (A) and rotators (B) with retainer locks (C). RG8326 5. Compress valve springs using JDG982 Valve Spring Installing Valve Rotators Compressor and install retainer locks on valve stems. 6.
Strike end of each valve several times with a soft, (non-metallic) hammer to ensure retainer locks are properly seated. 7. Recheck valve recess. (See CHECK VALVE HEIGHT –UN–06DEC97 IN RELATION TO HEAD SURFACE, earlier in this group.) A—Valve Springs RG8327 B—Rotators C—Retainer Locks Installing Valve Retainer Locks –UN–21MAY98 RG8328 Seating Valve Retainer Locks RG,RG34710,91 –19–13AUG99–2/2 02 020 39