Delphi — Install Valves

Cylinder Head and Valves Install Valve Seat Inserts 1. Use JDG164A Pilot Driver (A) and JDG1166 Valve Seat Insert Installing Adapter (B) to install valve seat inserts in cylinder head. 02 020 38 2. Install valves and measure valve recess. (See CHECK VALVE HEIGHT IN RELATION TO HEAD SURFACE, earlier in this group.) RG8319 –UN–06DEC97 3. Grind valve seats as required to maintain correct valve recess and valve face-to-seat seal. (See GRIND VALVE SEATS earlier in this group.) Valve Seat Pilot Driver IMPORTANT: A common practice is to chill valve seat inserts in a freezer before installing. This chilling process allows for less interference when pressing in valve seats.

Once inserts heat up to room temperature, original press-fit is restored. RG8318 –UN–21MAY98 A—JDG164A Pilot Driver B—JDG1166 Adapter Installing Valve Seat Insert RG,RG34710,90 –19–03NOV99–1/1 Install Valves 1. Lubricate valve stems and guides with AR44402 Valve Stem Lubricant or clean engine oil. NOTE: Valve must move freely in guide and seat properly with inserts to form an effective seal. RG8306A –UN–06DEC97 2. Insert valves in head (if valves are reused, install in same location from which removed). 3. Slide valve stem seals (A) over valve stems and onto intake and exhaust valve guide tower until firmly seated.

Installing Valve Stem Seals A—Valve Stem Seals CTM100 (06APR04) 02-020-38 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,91 –19–13AUG99–1/2 040604 PN=110