Delphi — Replace Unit Injector Sleeve in Cylinder Head Using JDG1184

Cylinder Head and Valves CTM100 (06APR04) 02-020-47 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=119 6. Plug oil drain cavities in cylinder head with clean, lint-free shop towels to prevent debris and hardware from falling into drain cavity. 7. Remove rocker arm cover. (See REMOVE AND INSTALL ROCKER ARM COVER in this group.) –UN–21JUL99 8. Remove appropriate rocker arm assembly: • Remove front rocker arm assembly for replacement RG9160A of injector sleeves 1 and 2. • Remove both front and rear rocker arm assemblies for replacement of injector sleeve 3. Cap Plug • Remove rear rocker arm assembly for replacement A—Cap Plug of injector sleeves 4, 5, and 6.

(See REMOVE ROCKER ARM ASSEMBLY in this group.) NOTE: If all six injector sleeves are to be replaced, replace sleeves for cylinders 1 and 6, 2 and 5, 3 and 4 at the same time so crankshaft has to be rotated only three times. 9. Remove electronic unit injector from injector sleeve that is to be replaced. Refer to the appropriate fuel system repair manual. Delphi/Lucas ECU controlled fuel systems: • See REMOVE AND INSTALL ELECTRONIC UNIT INJECTORS in CTM115, Section 02, Group 090. John Deere Level 6 ECU controlled fuel systems: • See REMOVE AND INSTALL ELECTRONIC UNIT INJECTORS in CTM188, Section 02, Group 090 (dual rail fuel systems).

• See REMOVE AND INSTALL ELECTRONIC UNIT INJECTORS in CTM188, Section 02, Group 091 (single rail fuel systems). IMPORTANT: Injector sleeve tip MUST BE plugged to keep debris out of power cylinder while tapping (threading) sleeve for removal. 10. Install small red cap plug (A) into injector sleeve tip. Be sure plug is firmly seated in tip of sleeve. Continued on next page DPSG,OUO1004,929 –19–16JUL99–3/15 02 020 47