Cylinder Head and Valves IMPORTANT: DO NOT attempt to tap threads in injector sleeve (for removal) unless JDG1184-1-3 Protector Sleeve (A) is anchored against injector sleeve with EUI hold-down clamp. This will eliminate injector sleeve turning in swedged bore of cylinder head. 02 020 48 RG9161A –UN–21JUL99 11. Thoroughly clean and dry JDG1184-1-3 Protector Sleeve as needed. Install protector sleeve into EUI bore until it is seated with injector sleeve. JDG1184-1-3 Protector Sleeve A—JDG1184-1-3 Protector Sleeve DPSG,OUO1004,929 –19–16JUL99–4/15 12. Install EUI hold-down clamp and cap screw (A) over protector sleeve. Tighten cap screws to 40 (30 lb-ft).
A—Hold-Down Cap Screw RG9162A –UN–21JUL99 Hold-Down Cap Screw Continued on next page DPSG,OUO1004,929 –19–16JUL99–5/15 CTM100 (06APR04) 02-020-48 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=120