Cylinder Head and Valves 18. Thread JDG1184-1-2 Screw Adapter (A) with JDG1184-1-4 Spacer (B) into threaded injector sleeve finger tight. This will keep shavings out of fuel rail. 19. Thread D01300AA 2.2 kg (5 lb) Slide Hammer into screw adapter. RG9164A –UN–21JUL99 20. Pull injector sleeve from cylinder. Remove puller attachments from injector sleeve. 21. Remove injector sleeve packing from groove in cylinder head using O-ring pick. 22. Thoroughly clean and dry protector sleeve for future use. Clean remaining components as necessary.
Adapter and Spacer A—JDG1184-1-2 Screw Adapter B—JDG1184-1-4 Spacer RG9165 –UN–21JUL99 CTM100 (06APR04) 02-020-49 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page Remove Sleeve DPSG,OUO1004,929 –19–16JUL99–7/15 040604 PN=121 13. Apply a generous amount of all-purpose grease to JDG1184-1-1 Tap (A). 14. Position JDG1184-1-5 Tap Guide (B) over shaft of tap to center tap in protector sleeve. –UN–21JUL99 15. Tap at least five full threads in ID of injector sleeve using a 5/8 in., 12-point socket and extension with a ratchet or T-handle. RG9163A 16. Once resistance increases on tap, reverse direction and remove tap. JDG1184-1-1 Tap IMPORTANT:
DO NOT remove protector sleeve from A—JDG1184-1-1 Tap nozzle sleeve after tapping screw B—JDG1184-1-5 Tap Guide threads. Sleeve MUST BE removed as an assembly with JDG1184-1-2 Screw Adapter and JDG1184-1-4 Spacer to contain shavings and protect fuel rail in head. 17. Remove cap screw and EUI hold-down clamp from protector sleeve. Do not remove sleeve at this time. DPSG,OUO1004,929 –19–16JUL99–6/15 02 020 49