Cylinder Head and Valves Check Piston Position in Liner 1. After injector sleeve is removed, look into sleeve bore of cylinder head to be sure that piston is at or near bottom of its stroke. 02 020 50 2. If piston is not near bottom, rotate engine flywheel using JDG820 Flywheel Rotation Tool (A). RG8226 –UN–05DEC97 A—JDG820 Flywheel Rotation Tool Rotate Engine Flywheel DPSG,OUO1004,929 –19–16JUL99–8/15 Install Injector Sleeve 1. Install JDG1184-1-3 Protector Sleeve (A) into injector sleeve bore (without injector sleeve). 2. Install EUI hold-down clamp (B) and cap screw over protector sleeve. Tighten cap screw to 40 (30 lb-ft). RG9162B –UN–21JUL99 3.
Thoroughly clean injector sleeve bore with a small brush. 4. Remove protector sleeve. Install Protector Sleeve A—JDG1184-1-3 Protector Sleeve B—Hold-Down Clamp Continued on next page DPSG,OUO1004,929 –19–16JUL99–9/15 CTM100 (06APR04) 02-020-50 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=122