Delphi — Replace Unit Injector Sleeve in Cylinder Head Using JDG1184

Cylinder Head and Valves 7. Lubricate O-rings with clean engine oil and position JDG981-1 Guide Sleeve (A) into injector sleeve and seat sleeve using a plastic or rubber hammer. Be careful not to cut O-rings. NOTE: When injector sleeve is fully seated, top of JDG981-1 Guide Sleeve should be slightly lower than top of valve rotators. RG9167A –UN–21JUL99 A—JDG981-1 Guide Sleeve Seat Sleeve CTM100 (06APR04) 02-020-51 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page DPSG,OUO1004,929 –19–16JUL99–11/15 040604 PN=123 5. Lubricate new square packing with clean engine oil or grease and install into packing bore in cylinder head. IMPORTANT:

Old injector sleeve (B) with one O-ring MUST be replaced with new injector sleeve (C) with two O-rings. –UN–04SEP02 6. Lubricate O-rings with engine oil and install injector sleeve (A) into cylinder bore. RG12418 A—Injector Sleeve B—Old Injector Sleeve Installing Sleeve C—New Injector Sleeve –UN–04SEP02 RG12415 DPSG,OUO1004,929 –19–16JUL99–10/15 02 020 51