Delphi — Install Rocker Arm Assembly

IMPORTANT: Thoroughly inspect intake and exhaust valve bridges (A) for proper seating on valve stems (B) from both sides of engine. Also, make sure that push tubes (C) are properly seated in top of valve bridges. Use a flashlight and carefully check each bridge (for proper seating on valve stems) from both sides of the engine. Lift up on each bridge to verify proper seating. Valve bridges that are not properly seated on valve stems will result in major engine failure. RG9743 –UN–04DEC98 Before installing rocker arm cover, make sure that all EUI wires are positioned so that rocker arm will not contact wires when engine is running. Inspect Bridges and Push Tubes 4. Install rocker arm cover.

(See REMOVE AND INSTALL ROCKER ARM COVER, earlier in this group.) A—Valve Bridge B—Valve Stems C—Push Tube RG,RG34710,97 –19–01NOV00–9/9 CTM100 (06APR04) 02-020-67 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=139 Cylinder Head and Valves Specification Unit Injector Wiring Harness Solenoid Wire Retaining Nut1— Torque...........................................................................3.0 N•m (27 lb-in.) Unit Injector Harness Clips-to-Rocker Arm Shaft Clamps—Torque.............................................................. 35 N•m (26 lb-ft) 3. Adjust valve-to-bridge clearance and injector preload.

(See CHECK AND ADJUST VALVE ASSEMBLY CLEARANCES AND INJECTOR PRELOAD, earlier in this group.) 1Apply LOCTITE 222 (TY24311) Thread Lock and Sealer (Low Strength) to nut only. RG,RG34710,97 –19–01NOV00–8/9 02 020 67