Delphi — Remove Pistons and Connecting Rods

Cylinder Block, Liners, Pistons, and Rods IMPORTANT: Do not rotate crankshaft with cylinder head removed unless liners are bolted down. Bolt liners down before removing piston. 02 030 Cap screws and washers must be tightened to 68 N m (50 lb-ft) to achieve an accurate reading when checking liner standout (height above block), as detailed later in this group. 8 RG8302 –UN–06DEC97 5. Use seven M16 x 2.0 x 55 mm (2.17 in.) long cap screws (A) and 5/8 in. ID x 1-3/4 in. OD x 3.18 mm (1/8 in.) thick washers (B) to bolt down cylinder liners (C) in the seven locations as shown. Tighten cap screws to specifications.

Bolting Liners Down A—Long Cap Screws B—Thick Washers C—Bolt Down Cylinder Liners Specification Cylinder Liner Cap Screws (For Checking Liner Standout)— Torque 68 (50 lb-ft) ............................................................................. 6. Before removing pistons, visually inspect condition of cylinder liners with pistons at bottom dead center Liners will require replacement if: The crosshatch honing pattern is not visible immediately below the top ring turn-around area. Liners are pitted or contain deep vertical scratches that can be detected by the fingernail. No further inspection is required if any one of the above conditions is found.

Continued on next page RG,RG34710,107 –19–01NOV00–2/4 CTM100 (06APR04) 02-030-8 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=148