CTM100 (06APR04) 02-030-7 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=147 Cylinder Block, Liners, Pistons, and Rods Remove Pistons and Connecting Rods The engine does not always have to be removed from the machine to service the pistons and connecting rods. If engine is to be removed, see your Machine Technical Manual. –UN–05DEC97 NOTE: The piston and liner sets on later 12.5 L engines are different from earlier engines. Do not mix sets in engines. See parts catalog for correct applications. RG8203 Piston and Rod Exploded View CAUTION: DO NOT drain engine coolant until it cools below operating temperature. Then slowly loosen block drain valve to relieve any pressure. 1.
Drain all coolant and engine oil. –UN–06DEC97 2. Remove all piston spray jets. NOTE: If engine is to be completely disassembled, follow ENGINE DISASSEMBLY SEQUENCE in Group RG8299B 010. 3. Remove cylinder head. (See REMOVE CYLINDER Removing Piston Spray Jets HEAD in Group 020.) A—Piston with Rings B—Piston Pin 4. Remove oil pan. (See REMOVE ENGINE OIL PAN in C—Snap Ring (2 used) Group 060.) Remove oil pick-up tube. (See REMOVE D—Connecting Rod with Bushing AND INSTALL OIL PICKUP TUBE in Group 060.) E—Rod Bearings F—Connecting Rod Cap G—Special Cap Screws H—Piston Spray Jet Continued on next page RG,RG34710,107 –19–01NOV00–1/4 02 030 7