Cylinder Block, Liners, Pistons, and Rods 8. Mark rods, pistons, and caps to ensure correct assembly in same location. IMPORTANT: Keep bearing inserts with their respective caps for rod and main bearings. 02 030 10 9. Remove all rod caps (A) with bearings. RG8396A –UN–09DEC97 NOTE: Use PLASTIGAGE to determine bearing-to-journal oil clearance as directed by the manufacturer. PLASTIGAGE will determine bearing-to-journal oil clearance, but will not indicate the condition of either surface. Removing Rod Caps 10. Measure rod bearing-to-journal oil clearance with PLASTIGAGE before removing piston and rod assembly. Record measurements.
(See INSPECT AND MEASURE CONNECTING ROD BEARINGS, later in this group.) RG8398 –UN–21MAY98 IMPORTANT: Hold on to piston to prevent piston from dropping. Piston will drop once piston rings have cleared cylinder liner bore. If liners are to be reused, be extremely careful not to let connecting rod hit liner bore when removing piston and rod assembly. Measuring Rod Bushing Oil Clearance A—Rod Caps 11. Gently tap piston through top of cylinder block from the bottom. 12. Remove remaining pistons and rods from engine. PLASTIGAGE is a registered trademark of DANA Corp. RG,RG34710,107 –19–01NOV00–4/4 CTM100 (06APR04) 02-030-10 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=150